Phoenix tap water had a total hardness of 172 to 302 ppm, or 10 to 17.6 grains per gallon, in the City of Phoenix’s 2025 water quality report. That’s hard to very hard on the USGS scale. If you run a softener, set it to about 18 gpg, the top of the range, because the city doesn’t publish separate figures for each part of its system.
On this page
10–17.6 gpg 172–302 mg/L · 2025 range
City of Phoenix, 2025 Water Quality Report. Marker at the top of the range. Scale: USGS classes up to 300 mg/L.
| Total hardness, 2025 | 172–302 ppm (mg/L as CaCO3) = 10–17.6 gpg |
|---|---|
| USGS class | Hard (121–180 mg/L) at the low end, very hard (over 180) for most of the range |
| Suggested softener setting | 18 gpg (top of the range, rounded up) |
| Sodium, 2025 | 91–183 ppm before any softening |
| Total dissolved solids | 464–716 ppm |
| Sources | Salt, Verde and Colorado rivers (about 97–99%), plus about 20 city wells |
| Utility | City of Phoenix Water Services Department, about 1.7 million residents |
Why Phoenix water is so hard
Almost all of Phoenix’s water starts as snow. The 2025 report says about 97 to 99 percent came from surface water that mostly began as snowpack, carried by the Salt, Verde and Colorado rivers.
On the way to the city that water crosses a lot of desert rock and soil. The city’s water quality FAQ explains that hardness comes from calcium and magnesium the water picks up along its route.
The Colorado River share arrives through the Central Arizona Project canal. That’s the same river that supplies the Las Vegas valley, where the utility reports about 16 gpg. Salt and Verde river water comes through the Salt River Project canals. The river also reaches San Diego, where the city’s plants averaged 13.8 to 14.2 gpg in 2025: San Diego water hardness.
The remaining one to three percent comes from around 20 city-run groundwater wells.
Why the figure is a range, not one number
Phoenix treats water at five plants, and each one draws on a different mix of rivers. The report gives one citywide range for hardness rather than a figure per plant, so it can’t tell you which end of the range reaches your home.
The mix can also change. The report notes, for example, that Agua Fria River water is blended with Colorado River water in Lake Pleasant.
That’s why the safe softener setting is the top of the range. If you want a precise figure for your tap, test it: our guide on how to test water hardness compares strips, drop kits and labs. The city also answers questions through its water quality contact listed in the report.
Phoenix water hardness in other units
The city gives 172 to 302 ppm, which is 10.0 to 17.6 gpg, 9.6 to 16.9 °dH and 1.72 to 3.02 mmol/L (SofterTap conversions). Dishwashers usually ask for German degrees or mmol/L; at 17 °dH (3.0 mmol/L), most manuals put Phoenix water in one of their upper levels. Our dishwasher hardness setting guide shows how the levels map, and the water hardness converter turns any other figure into every unit.
What 10 to 17.6 gpg means at home
Water this hard leaves scale wherever it’s heated or left to dry. Expect a crust in kettles and coffee makers within weeks, white spots on glasses and shower doors, and scale inside water heaters.
The city’s report says it plainly: hard water can cause some types of scaling in pipes and water heaters. Hardness isn’t a health standard, though. The city’s FAQ notes that taste, odour and hardness are not regulated under drinking water health standards.
Tankless water heaters deserve a look at the warranty. Some manufacturers exclude damage above a stated hardness: Noritz, for example, excludes water above 12 gpg. The top of Phoenix’s range is well over that. Our page on tankless heaters and hard water has the details.
Softener size and salt use in Phoenix
Sizing a softener on the top of the range, 17.6 gpg, at 80 gallons per person per day, a family of four removes 39,424 grains a week. That needs a 64,000-grain unit at a medium salt setting and, with an efficiency-rated softener, about 614 lb of salt a year (15.3 bags of 40 lb, $134 at $8.76 a bag). One person uses about 153 lb ($34) and six people about 920 lb ($202).
If your water turns out to be at the soft end of the range, around 10 gpg, a family of four would need about 349 lb of salt a year instead of 614. That gap is why a home test pays for itself before you buy.
This calculator needs JavaScript. The table above covers 1 to 6 people.
Sodium: Phoenix starts high
Phoenix water already carries 91 to 183 ppm of sodium before it reaches a softener, according to the 2025 report. A salt-based softener adds more, because it swaps hardness for sodium; the rate is worked out in potassium chloride vs salt. At Phoenix hardness that’s roughly 79 mg/L extra at 10 gpg and 139 mg/L extra at 17.6 gpg.
Added to the city’s own figures, fully softened Phoenix water would land somewhere between about 170 and 320 mg/L of sodium. If you watch your sodium intake, ask your doctor, and consider an unsoftened kitchen tap or potassium chloride instead of salt.
Suburbs and other utilities
The Phoenix metro is served by many separate utilities. Scottsdale, Mesa, Chandler, Gilbert, Tempe, Glendale and Peoria all publish their own reports, and some areas inside Phoenix’s own service area, such as Anthem, have separate systems with separate reports.
Check the name on your water bill and use that utility’s report. Our guide to reading a water quality report shows where hardness usually sits. Then compare with other cities in water hardness by city.
Sizing for your household? Enter your hardness and the number of people, and the calculator shows the softener size and salt use step by step.
Frequently asked questions
Is Phoenix water hard?
Yes. The 2025 range of 172 to 302 ppm is hard at the low end and very hard for most of the range on the USGS scale.
What should I set my water softener to in Phoenix?
About 18 gpg, the top of the city’s 2025 range rounded up, unless a test of your own tap gives a lower figure. Our hardness setting guide explains why the high figure is safer.
Why is Phoenix water so hard?
Its rivers pick up calcium and magnesium from the rock and soil they cross on the way to the city, and the Colorado River is already hard when it arrives through the CAP canal.
Does Phoenix soften its water?
The 2025 report doesn’t describe any softening step, and the hardness figures it publishes are the hardness at your tap.
Is Phoenix water safe to drink?
Hardness isn’t a health standard. For safety questions, the city’s annual report lists every regulated contaminant and its results.
Sources
- City of Phoenix: 2025 Water Quality Report (PDF): hardness 172–302 ppm, sodium 91–183 ppm, sources
- City of Phoenix: Water quality FAQ (April 2024, PDF)
- USGS Water Science School: Hardness of Water
- Morton Salt: Water softening FAQs (sodium added per grain)
- Noritz: Limited warranty, tankless (PDF)
- PNNL Building America Solution Center: Water Softeners (NSF/ANSI 44 efficiency rating)
